From ArchWiki
Revision as of 01:38, 11 March 2013 by Fengchao (Talk | contribs) (Suspend to RAM/Disk: uswsusp development discontinued.)

Jump to: navigation, search

This page describes troubleshooting and configuration specific to the Asus A6km laptop.

On this model, a known buggy BIOS problem results in a system hang when any USB device, such as a mouse, is attached at bootup. This can be fixed using a downgraded BIOS version (can be downloaded here). The installation described uses this 202 BIOS version and so far no problems have been encountered, even the power management modules behave properly.

See the Beginners' Guide for installation instructions.


  • 1.8GHz AMD Turion 64 ML34 Processor
  • 15.4" XGA Widescreen TFT Screen
  • 256MB Nvidia Geforce Go 7300
  • 100GB Hard Drive
  • RTL-8169 Gigabit Ethernet Integrated Card
  • Broadcom Integrated 802.11g wireless card
  • DVD Dual Layer Drive
  • Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro
  • 1.3 Mega Pixel USB Intergrated Camera
  • SiS AC'97 Sound Card

lspci outout:

00:00.0 Host bridge: Silicon Integrated Systems [SiS] Device 0756 (rev 02)
00:01.0 PCI bridge: Silicon Integrated Systems [SiS] PCI-to-PCI bridge
00:02.0 ISA bridge: Silicon Integrated Systems [SiS] SiS964 [MuTIOL Media IO] (rev 36)
00:02.5 IDE interface: Silicon Integrated Systems [SiS] 5513 [IDE] (rev 01)
00:02.6 Modem: Silicon Integrated Systems [SiS] AC'97 Modem Controller (rev a0)
00:02.7 Multimedia audio controller: Silicon Integrated Systems [SiS] AC'97 Sound Controller (rev a0)
00:03.0 USB Controller: Silicon Integrated Systems [SiS] USB 1.1 Controller (rev 0f)
00:03.1 USB Controller: Silicon Integrated Systems [SiS] USB 1.1 Controller (rev 0f)
00:03.2 USB Controller: Silicon Integrated Systems [SiS] USB 1.1 Controller (rev 0f)
00:03.3 USB Controller: Silicon Integrated Systems [SiS] USB 2.0 Controller
00:09.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
00:0a.0 CardBus bridge: Ricoh Co Ltd RL5c476 II (rev b3)
00:0a.1 FireWire (IEEE 1394): Ricoh Co Ltd R5C552 IEEE 1394 Controller (rev 08)
00:0a.2 SD Host controller: Ricoh Co Ltd R5C822 SD/SDIO/MMC/MS/MSPro Host Adapter (rev 17)
00:0a.3 System peripheral: Ricoh Co Ltd R5C592 Memory Stick Bus Host Adapter (rev 08)
00:0b.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8169 Gigabit Ethernet (rev 10)
00:18.0 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] HyperTransport Technology Configuration
00:18.1 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Address Map
00:18.2 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] DRAM Controller
00:18.3 Host bridge: Advanced Micro Devices [AMD] K8 [Athlon64/Opteron] Miscellaneous Control
01:00.0 VGA compatible controller: nVidia Corporation G72M [Quadro NVS 110M/GeForce Go 7300] (rev a1)


For wireless, can use the b43-fwcutter package to install the firmware, (run lsmod command to check if the b43 module is running):

# b43-fwcutter -w /lib/firmware /path_to_driver

the driver can be found here


The sound card [SiS AC'97] was detected on installation and the correct modules for audio loaded at bootup.

See ALSA for installation/configuration details.


To get the touchpad working, install the synaptics package:

# pacman -S xf86-input-synaptics


The webcam was detected on installation and the modules loaded at bootup.

Linux video capture interface: v2.00
stkwebcam: Syntek USB2.0 Camera is now controlling video device /dev/video0

The cheese webcam package worked well with the installed drivers. Cheese is installed with Gnome extras packages. Can't recall whether this worked on the kernel version installed from the download or after an upgrade!

Kernel version in use at this stage was 2.6.27.


Not tested so far


First make sure the device is enabled in the BIOS, then once booted up, start the daemon:

# /etc/rc.d/irda start

One way to test the device is to install the utilities:

# pacman -S irda-utils

and run the command:

# irdadump

the output should look something like this when working:

13:13:59.173537 xid:cmd 851b3728 > ffffffff S=6 s=0 (14) 
13:13:59.263432 xid:cmd 851b3728 > ffffffff S=6 s=1 (14) 
13:13:59.353394 xid:cmd 851b3728 > ffffffff S=6 s=2 (14) 
13:13:59.443431 xid:cmd 851b3728 > ffffffff S=6 s=3 (14) 
13:13:59.533395 xid:cmd 851b3728 > ffffffff S=6 s=4 (14) 
13:13:59.626729 xid:rsp 851b3728 < 26098ceb S=6 s=4 Sony Ericss hint=9124 [ PnP Modem IrCOMM  IrOBEX ] (28) 
13:13:59.633430 xid:cmd 851b3728 > ffffffff S=6 s=5 (14) 
13:13:59.723433 xid:cmd 851b3728 > ffffffff S=6 s=* asus-archlinux-64 hint=0400 [ Computer ] (33) 

The 'Sony Ericss' entry is a nearby (direct line of sight) mobile phone with infra-red enabled.

There should also be an irda0 entry when running the ifconfig command.

Card Reader

Not tested so far

Tv Out

Not tested.

Other Software/Utilities

Power Management

For cpu scaling, see CPU Frequency Scaling.

Suspend to RAM/Disk

For suspend-to-ram, follow the instructions in the Suspend to RAM page.