ASUS Eee PC 1001px

From ArchWiki
Revision as of 11:45, 25 October 2010 by Avirisu (Talk | contribs) (Sound)

Jump to: navigation, search


Introduction

How to install Arch Linux on the Asus Eee PC 1001px.

This article was written for the stock kernel 2.6.34-ARCH. The netbook runs absolutely fine after little configuration.

The same model was sold in Germany under the name Eee PC R101.

Installation

The netbook probably comes with a 32bit-Windows installed. The Intel Atom 450N however supports x86_64-instructions and 64bit-Arch runs perfectly fine.

To boot from an USB stick it is neccessary to deactivate the "Boot Booster"-option in the BIOS or otherwise the Asus seems to skip all detection scans and will just boot from harddisk. Press F2 repeatedly during the fortunately short POST to enter the BIOS. Deactivate "Boot Booster" and select your USB stick as the first HDD in the HDD list. (The "Removable Device" in the main boot devices list is something different.)

When partitioning you may want to keep the EFI-partition (usually the last, smallest partition). It allows to use the "Boot Booster"-Feature and to jump over certain tests before booting. Don't panic however if you deleted it, the partition may be restored. Look on the eeePC-Forum for it.

Sound

The soundcard is correctly recognized but alsa does not feature the correct model-option (yet) to setup the rather interesting pin connections. What works mostly is adding

  options indel-hda-snd model=lifebook

to your /etc/modprobe/modprobe.conf. I did not however get the internal microphone working. The external microphone over the combined audio jack was not tested.

To get the internal microphone working, add

  options snd-hda-intel model=fujitsu

to the /etc/modprobe/modprobe.conf then with pulseaudio volume control mute one side of the microphone

Laptop Mode Tools & powersaving

The powersaving-mechanisms provided by Laptop Mode Tools seem to work.

Standby (Suspend-to-ram) works perfectly fine with hotkey. Hibernate (Suspend-to-disk) was not tested.

CPU frequency scaling works. After installing Cpufrequtils and adding acpi-cpufreq to your MODULES in /etc/rc.conf laptop-mode does a perfectly fine job taking care of your frequencies.

Spinning down the harddrive works.

Adjusting the brightness of the display works with hotkeys after adding the following to your kernel-boot-options

 acpi_osi=Linux acpi_backlight=vendor

To adjust the brightness from the command line, you can write values 0 to 10 (inclusive) to /sys/devices/virtual/backlight/acpi_video0/brightness .

Personal Remark: The overall endurance seems good. While I never actually reached the promised 10h, 8h-9h are possible with dimmed display, 4h while really working with it. The power-saving-support is probably not worse than on windows.

Issueless hardware

Graphics

The integrated GPU (Pineview) is supported with KMS by i915 meaning xf86-video-intel.

(W)LAN

The WLAN-chip is fully supported by ath9k in all three modes of operation (b/g/n). Ethernet works fine.

Input

Webcam and Touchpad work.

Keyboard also does its job.

SD Card reader works.

Fn keys

Install the package acpi-eeepc-generic 1.0rc3-0.1[1] from AUR and copy the file /etc/acpi/eeepc/models/acpi-eeepc-1001P-events.conf to a file called acpi-eeepc-1001PX-events.conf in the same folder. All buttons work but you still need to edit the file /etc/conf.d/acpi-eeepc-generic.conf to your liking.

Hardware information

lspci

00:00.0 Host bridge: Intel Corporation Pineview DMI Bridge
00:02.0 VGA compatible controller: Intel Corporation Pineview Integrated Graphics Controller
00:02.1 Display controller: Intel Corporation Pineview Integrated Graphics Controller
00:1b.0 Audio device: Intel Corporation 82801G (ICH7 Family) High Definition Audio Controller (rev 02)
00:1c.0 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 1 (rev 02)
00:1c.1 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 2 (rev 02)
00:1c.3 PCI bridge: Intel Corporation 82801G (ICH7 Family) PCI Express Port 4 (rev 02)
00:1d.0 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #1 (rev 02)
00:1d.1 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #2 (rev 02)
00:1d.2 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #3 (rev 02) 
00:1d.3 USB Controller: Intel Corporation 82801G (ICH7 Family) USB UHCI Controller #4 (rev 02)
00:1d.7 USB Controller: Intel Corporation 82801G (ICH7 Family) USB2 EHCI Controller (rev 02)
00:1e.0 PCI bridge: Intel Corporation 82801 Mobile PCI Bridge (rev e2)
00:1f.0 ISA bridge: Intel Corporation Tigerpoint LPC Controller (rev 02)
00:1f.2 SATA controller: Intel Corporation 82801GR/GH (ICH7 Family) SATA AHCI Controller (rev 02)
00:1f.3 SMBus: Intel Corporation 82801G (ICH7 Family) SMBus Controller (rev 02)
01:00.0 Ethernet controller: Atheros Communications Atheros AR8132 / L1c Gigabit Ethernet Adapter (rev c0)
02:00.0 Network controller: Atheros Communications Inc. AR9285 Wireless Network Adapter (PCI-Express) (rev 01)

lsusb

Bus 005 Device 002: ID 0b05:1788 ASUSTek Computer, Inc. 
Bus 005 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 004 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 003 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 002: ID 13d3:5119 IMC Networks 
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub