Ad-hoc networking

From ArchWiki
Revision as of 21:50, 10 April 2011 by Danny8 (talk | contribs) (Added to wireless sub-category, as well as retaining within "networking" category)
Jump to: navigation, search

You can setup ad-hoc networking to make two computers communicate or share an internet connection. The following scripts serve as an example. You will have to change the interface names for this to work on your system.

On the server

The server script works for a wireless card with an atheros driver. To make it work with a different card is trivial. More info there: If you just want to connect two computers with no sharing of internet connection, you can leave out the iptables bit in the server script.

####### this part should change or simply be removed depending on the network card
#recreates the ath0 interface in ad hoc mode
modprobe -r ath_pci
modprobe ath_pci autocreate=adhoc
wlanconfig ath0 destroy
wlanconfig ath create wlandev wifi0 wlanmode adhoc

#starts the ad hoc server
ifconfig ath0 down
iwconfig ath0 mode ad-hoc
iwconfig ath0 channel 4
iwconfig ath0 essid 'mine'
ifconfig ath0 up

#forwards the ad hoc network to the router
iptables -A FORWARD -i ath0 -o eth0 -s -m state --state NEW -j ACCEPT
iptables -A FORWARD -m state --state ESTABLISHED,RELATED -j ACCEPT
iptables -A POSTROUTING -t nat -j MASQUERADE
sh -c "echo 1 > /proc/sys/net/ipv4/ip_forward"

Here is a WPA Supplicant config file WPA based adhoc network.


On the client

Run the following on the client. If you want multiple clients, you will have to change the IP address to be unique.

iwconfig eth1 essid mine
iwconfig eth1 mode Ad-Hoc
ifconfig eth1 up
route add default gw

To share an internet connection, you need to tell the clients about the DNS servers. See the /etc/resolv.conf file on the server.