Difference between revisions of "Arch Linux VirtualBox Guest"

From ArchWiki
Jump to: navigation, search
(package changed name)
(Auto-start modules: what were the '#' for?)
Line 13: Line 13:
 
To autostart these modules each time you boot, you can either
 
To autostart these modules each time you boot, you can either
 
*1) Add the three modules above to the MODULES array in /etc/rc.conf.
 
*1) Add the three modules above to the MODULES array in /etc/rc.conf.
  #MODULES(... vboxguest vboxsf vboxvideo)
+
  MODULES(... vboxguest vboxsf vboxvideo)
 
'''OR'''
 
'''OR'''
 
*2) Add rc.vboxadd to the DAEMONS array. This daemon probes the above listed modules.  
 
*2) Add rc.vboxadd to the DAEMONS array. This daemon probes the above listed modules.  
  #DAEMONS(... rc.vboxadd)
+
  DAEMONS(... rc.vboxadd)
  
 
==Enable VboxClient-all:==
 
==Enable VboxClient-all:==

Revision as of 17:11, 24 July 2011

Installing Arch under VirtualBox is straightforward, and additions should be installed through pacman (not through "Install Guest Additions" in VirtualBox, or a mounted ISO.) Follow these instructions after doing a basic install of the X-window system found on the Beginners' Guide.

Install the required package:

# pacman -Syu virtualbox-archlinux-additions

Load vbox modules:

# modprobe vboxguest
# modprobe vboxsf
# modprobe vboxvideo

Auto-start modules

To autostart these modules each time you boot, you can either

  • 1) Add the three modules above to the MODULES array in /etc/rc.conf.
MODULES(... vboxguest vboxsf vboxvideo)

OR

  • 2) Add rc.vboxadd to the DAEMONS array. This daemon probes the above listed modules.
DAEMONS(... rc.vboxadd)

Enable VboxClient-all:

If you are running something that launches /etc/xdg/autostart/vboxclient.desktop, such as GNOME, then you should be ready to go. If you use .xinitrc to launch things instead, you must add

VBoxClient-all &

to your .xinitrc before launching your WM.

You should now be all set, and all guest additions should work properly.