Difference between revisions of "Brother DCP-7030"
(→Original) |
Aaronmueller (talk | contribs) (→Drivers) |
||
(2 intermediate revisions by one other user not shown) | |||
Line 20: | Line 20: | ||
Install drivers: | Install drivers: | ||
% yaourt -S brother-dcp7030 | % yaourt -S brother-dcp7030 | ||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
− | |||
Run | Run | ||
− | # /usr/local/Brother/cupswrapper/cupswrapperDCP7030-2.0.2 | + | # /usr/local/Brother/cupswrapper/cupswrapperDCP7030-2.0.2 |
Now go to the CUPS page: http://localhost:631/ | Now go to the CUPS page: http://localhost:631/ |
Revision as of 10:04, 4 September 2013
Contents
Introduction
This is a brief tutorial how to setup the Brother DCP-7030 (multi function laser copier printer) on i686 Arch.
Printer
CUPS
Install CUPS (see CUPS page).
Usblp
It may be necessary to blacklist Usblp module to get AUR driver working. To do that, you may add "!usblp" at the end of your rc.conf MODULES list.
Drivers
Original
There is the brother-dcp7030 in AUR. It contains driver from Brother.
Install drivers:
% yaourt -S brother-dcp7030
Run
# /usr/local/Brother/cupswrapper/cupswrapperDCP7030-2.0.2
Now go to the CUPS page: http://localhost:631/
Under the Printers tab you should see a DCP7030 printer automatically installed and configured.
Using PPD from hl1250
Unfortunately original driver did not work with DCP-7030 on my PC.
I got this PPD. I replaced all DCP-7020
by DCP-7030
. After this I add a new printer manually using this PPD.
Udev
It may be nesessary to add a rule to your udev:
# nano /etc/udev/rules.d/10-usbprinter.rules
ATTR{idVendor}=="04f9", ATTR{idProduct}=="01ea", MODE:="0664", GROUP:="lp", ENV{libsane_matched}:="yes"
Installation
Go to http://localhost:631 page in your browser and install printer. All settings there is very simple, the main thing you must check - paper size set to "A4".
Scanner
SANE
Install SANE:
# pacman -S sane
Add your user to scanner
group:
# gpasswd -a username scanner
Drivers
There is the brscan3 in AUR.
Install drivers:
% yaourt -S brscan3
After installing add line brother3
in the /etc/sane.d/dll.conf
.
Now you can try to see if SANE recognizes your scanner
$ scanimage -L
For more info see SANE page.
If your scanning software can't use the scanner even with correct scanimage, check your printer usb location with
$ lsusb
and give writing permission for that device to all users. For example, for:
Bus 008 Device 004: ID 04f9:01ea Brother Industries, Ltd DCP-7030
use:
# sudo chmod a+w /dev/bus/usb/002/004
Troubleshooting
If you can print a test page from http://localhost:631, but can't print anything from LibreOffice, try to install a2ps.