Brother DCP-7030

From ArchWiki
Revision as of 10:47, 12 March 2011 by Gray (talk | contribs) (Created page with "Category:Printers_(English) Category:Imaging_(English) Category:HOWTOs (English) =Introduction= This is a brief tutorial how to setup the Brother DCP-7030 (multi fu...")
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search


This is a brief tutorial how to setup the Brother DCP-7030 (multi function laser copier printer) on i686 Arch.



Unfortunately extra/cups did not work with DCP-7030 on my PC. But it works with cups-usblp from AUR.

So, if you are using yaourt you can get cups-usblp:

% yaourt -S cups-usblp

Check if usblp is loaded:

% lsmod | grep usblp

If it does not then load it manually:

# modprobe usblp

You can make it autoload at boot: add it to the MODULES=() in the Template:Filename

MODULES=(... usblp ...)

After installing cups-usblp, start CUPS by:

# /etc/rc.d/cups start

For automatically starting CUPS every time the system is powered on, add it to the DAEMONS=() in the Template:Filename:

DAEMONS=(... @cups ...)


There is the brother-dcp7030 in AUR.

Install drivers:

% yaourt -S brother-dcp7030

After installing brother-dcp7030 run

# /usr/local/Brother/cupswrapper/cupswrapperDCP7030-2.0.2

Now go to the CUPS page: http://localhost:631/

Under the Printers tab you should see a DCP7030 printer automatically installed and configured.

You need run cupswrapper only once! You do not need it run every time at startup.



Install SANE:

# pacman -S sane

Add your user to scanner group:

# gpasswd -a username scanner
Note: You need to logout/login for this to take effect.


There is the brscan3 in AUR.

Install drivers:

% yaourt -S brscan3

After installing add line brother3 in the {{Filename|/etc/sane.d/dll.conf}.

Now you can try to see if SANE recognizes your scanner

$ scanimage -L

For more info see SANE page.