Fast Arch Install from existing Linux System

From ArchWiki
Revision as of 21:57, 25 May 2010 by Rransom (talk | contribs) (Booting the ISO with LILO: rewrite)
Jump to: navigation, search

Template:I18n links start Template:I18n entry Template:I18n entry Template:I18n entry Template:I18n entry Template:I18n entry Template:I18n links end If you are running Linux already and don't have a CD writer---or if you simply want a faster install process---here is how to install Arch from another running Linux installation.

Read the Official Arch Linux Install Guide first so that you know what to expect.

You need one spare partition, at least as large as the Arch ISO image. Here I'm logged in as root and am using "/dev/sda12" which happens to be 6GB.


1) Write the ISO image onto the spare partition:

dd if=archlinux-2010.05-netinstall-x86_64.iso of=/dev/sda12 bs=4k

2) Making or using a suitable mount point, mount the partition somewhere (you can specify -t iso9660, but mount should auto-detect the filesystem type):

mkdir /mnt/archCD
mount /dev/sda12 /mnt/archCD

3) Read the kernel options in isolinux.cfg:

grep -e APPEND /mnt/archCD/boot/isolinux/isolinux.cfg

Remember the value of the initrd= and archisolabel= options; the other options are less important on most systems.

Booting the ISO with GRUB

Note: It is possible to boot the ISO image using LILO; see #Booting the ISO with LILO below.

1) Reboot the computer. When the GRUB menu appears, press 'c' for a command line.

2) Type:

root (hd#,#)

If you are using GRUB-Legacy, /dev/sda12 corresponds to (hd0,11); if you are using GRUB2, /dev/sda12 corresponds to (hd0,12).

3) Load the kernel:

kernel /boot/vmlinuz26 archisolabel=ARCH_201005

where ARCH_201005 is the value of archisolabel you memorized or wrote down above.

If you are using GRUB2, use linux instead of kernel in the above command.

4) Load the initial ramdisk:

initrd /boot/archiso.img

where /boot/archiso.img is the value of initrd you memorized or wrote down above.

5) Boot:


And to reclaim the spare partition when Arch is up and running...

1) The spare partition can be reclaimed by making a file system with "mkreiserfs", "mke2fs" etc. Using sda12 as an example:

mkreiserfs /dev/sda12

2) Then edit /etc/fstab to check the partition has the correct file system and options listed against it:

/dev/sda12 /mnt/spare reiserfs defaults,noatime,notail,noauto 0 0

3) Lastly check that the mount point exists, if not:

mkdir /mnt/spare

Booting the ISO with LILO

Warning: I have not tested this process; please remove this warning if it works for you.

1) Edit lilo.conf to add:


where /boot/archiso.img and ARCH_201005 are the values of initrd= and archisolabel= you memorized or wrote down above.

2) Run:


3) Reboot the computer; choose archCD at the LILO menu.