Full system backup with rsync
This rsync script allows creating a full backup copy across filesystems. It is setup so that the copy includes intact booting capabilities, optionally excluding selected files.
The approach has benefits over omitting system files by just copying personal data; if the system becomes corrupted in the main partition, overcoming the problem means booting into the backup as opposed to identifying and reinstalling affected programs.
Instructions were converted from this forum post.
Two files are needed: the backup script and a file stating which files to include/exclude from the backup source.
The script is very simple; it rsyncs in archive mode, ensuring that symbolic links, devices, permissions and ownerships, among other file attributes are preserved, while excluding files that match the patterns from the include/exclude list.
- Backup source; Template:Codeline
- In this case it's performing a backup on the whole root.
As deciding which files should populate this list can be difficult, here's a typical backup example that excludes common files that don't need to be backed up, such as the vast majority of Template:Filename. Note that specifying every desired file or directory in Template:Codeline is not needed; this section only acts as a filter for statements in Template:Codeline. This file is in the traditional include/exclude rsync format.
- Content in system directories; Template:Filename, Template:Filename, Template:Filename and Template:Filename are excluded because they are created by the system at runtime, while the directories themselves need to be preserved since they are not regenerated at boot. Lastly, all Template:Filename instances are skipped since they are partition-specific. For Archlinux Template:Filename can also be excluded. This can save a lot of time on every backup since the directory contains many small files that tend to change quite often. These are description files for every package from the repositories. These files can be regenerated with Template:Filename.
- Even though Template:Filename is excluded, 4 files that are not dynamically created by udev need to be preserved. These are Template:Filename, Template:Filename, Template:Filename and Template:Filename.
Substitute Template:Filename as appropriate, and mount the destination device:
# mount /dev/sdb1 /media/backup
Run the backup script (note that the trailing "Template:Filename" character is necessary):
# ./rbackup.sh /media/backup/
After the sync is finished, the backup destination's Template:Filename has to be modified, a boot loader needs to be installed on the backup destination, and configuration in the destination's Template:Filename requires to reflect the new location.
Edit the backup destination's fstab: Template:Command
Because rsync has performed a recursive copy of the entire root filesystem, all of the Template:Codeline mounpoints are problematic and will cause the backup boot to fail. In this example, all of the offending entries are replaced with a single one: Template:Command
As before, remember to use the proper device name and filesystem type.
Open the GRUB console:
Direct the install towards the destination device:
root (hd1,0) setup (hd1)
- root; Template:Codeline
- This should point to where the GRUB files are located--in this case, "Template:Codeline" means the second storage device (Template:Filename) and "Template:Codeline" is the first partition (Template:Filename).
- setup; Template:Codeline
- The command specifies where the actual boot loader is to be installed. In this example it is installed to the MBR of the second storage device.
The problem here is that even though the boot loader installs correctly, its menu entries are for the main system's partitions, not the backup system's.