From ArchWiki
Revision as of 19:11, 3 November 2012 by Marvin Sebuolv (Talk | contribs) (Create schematic symbol)

Jump to: navigation, search

Tango-document-new.pngThis article is a stub.Tango-document-new.png

Notes: please use the first argument of the template to provide more detailed indications. (Discuss in Talk:GEDA#)

The gEDA project has produced and continues working on a full GPL'd suite and toolkit of Electronic Design Automation tools. These tools are used for electrical circuit design, schematic capture, simulation, prototyping, and production. Currently, the gEDA project offers a mature suite of free software applications for electronics design, including schematic capture, attribute management, bill of materials (BOM) generation, netlisting into over 20 netlist formats, analog and digital simulation, and printed circuit board (PCB) layout.

The gEDA project was started because of the lack of free EDA tools for POSIX systems with the primary purpose of advancing the state of free hardware or open source hardware. The suite is mainly being developed on the GNU/Linux platform with some development effort going into making sure the tools run on other platforms as well.

(Source: gEDA homepage)


Installing geda-gaf will give you the schematic editor and attribute editor, which is available in the official repositories. It may also be necessary to install ttf-dejavu and ttf-liberation to get the correct font scaling.

Installing pcbAUR will give you the PCB editor, available from the AUR.

Also you can install xgsch2pcbAUR (AUR), graphical interface to the gsch2pcb command-line tool for converting *.sch to *.pcb.


First PCB

Create schematic symbol

You can create new as you are creating schematics themselves. Open an empty file

# gschem mysymbol.sym
and add pins with ap and attributes with aa. After you are done, do not forget to translate your symbol to absolute zero with
, if you don't, your symbol will probably be outside of your viewport once you are going to place it in your schematic.

Then check your symbol with

# gsymcheck -vv mysymbol.sym

Create PCB footprint

Create schematic

Run schematic editor:

# gschem

See also:

FAQ page

Create and route PCB

Export to gerber