Kile and TeX Live

From ArchWiki
Revision as of 21:18, 8 February 2009 by Warriant (talk | contribs)
Jump to: navigation, search


This article summarizes how to install the Kile LaTeX editor with TeXLive instead of TeTeX (which is no longer maintained). For additional information about how to install TeXLive on Arch Linux, visit the TeXLive article.

Step 1: Install TeXLive

The best way to start is installing the texlive-most package.

# pacman -Sy texlive-most

Make sure you have enabled the community archives (in /etc/pacman.conf). If you encounter errors during the installation complaining that commands could not be found, try running:

$ export PATH=$PATH:/opt/texlive/bin

before installing.

Step 2: Install KPDF, KDVI,..

Those packages have been regrouped under a single package named kdegraphics, except for gv, therefore, in order to install them, you have to type:

# pacman -S kdegraphics gv

Step 3: Install Kile

Finally you have to install Kile.

# pacman -S kile

Start Kile from you menu and check whether all dependencies are solved using "Settings > Systemcheck". Kile will ask you for the Acrobat Reader (the pacman package is called acroread) but that is optional.

Note that if you installed Kile before installing the required packages (like kdvi), you can still install them and have a fully working Kile install.

Enjoy Kile and TeXLive.


pdfTeX warnings

If you get warnings such as:

pdfTeX warning: pdflatex [...] fontmap entry for [...] already exists, duplicates ignored

try to remove the map files,, from the updmap.cfg and finally run updmap.