Kile and TeX Live
This article summarizes how to install the Kile LaTeX editor with TeXLive instead of TeTeX (which is no longer maintained). For additional information about how to install TeXLive on Arch Linux, visit the TeXLive article.
Step 1, install TeXLive
The best way to start is installing the texlive-most package.
pacman -Sy texlive-most
Make sure you have enabled the community archives (in /etc/pacman.conf). If you encounter errors during the installation complaining that commands could not be found, try running "export PATH=$PATH:/opt/texlive/bin" before installing.
Step 2, install KPDF, KDVI,..
Those packages have been regrouped under a single packages named kdegraphics, except for gv, therefore, in order to install them, you have to type:
pacman -S kdegraphics gv
Step 3, install Kile
Finally you have to install Kile.
pacman -S kile
Start Kile from you menu and check whether all dependencies are solved using "Settings > Systemcheck". Kile will ask you for the Acrobat Reader (the pacman package is called acroread) but that is optional.
Note that if you installed Kile before installing the required packages (like kdvi), you can still install them and have a fully working Kile install.
Step 4, pdfTeX warnings?
If you get warnings such as 'pdfTeX warning: pdflatex [...] fontmap entry for [...] already exists, duplicates ignored', try to remove the map files pcr8y.map, phv8y.map, ptm8y.map from the updmap.cfg and finally run updmap.
Enjoy Kile and TeXLive.