Difference between revisions of "Laptop"

From ArchWiki
Jump to navigation Jump to search
m (use i18n template)
Line 1: Line 1:
[[Category:HOWTOs (English)]]
 
[[Category:Laptops (English)]]
 
{{i18n|Laptop}}
 
= Setting Up For Laptops =
 
This page should contain links to pages needed for configuring a laptop for the best experience. Setting up a laptop is in many ways the same as setting up a desktop. However, there are a few key differences. When setting up a laptop with Arch Linux, the following points should be taken into consideration:
 
 
* Power consumption (how do I make the battery last the longest per charge?). Which leads to power management:
 
* Hard drive spindown. After how many minutes of inactivity should the hard drive be spun down?
 
* Screen shut off. After how many minutes of inactivity should the screen be shut off? (Not just blanked with a screensaver but completely shut off).
 
* CPU frequency scaling. How should the CPU's frequency change depending on load to minimize power usage?
 
* Suspend and hibernate. How do I get suspend and hibernate to work with my laptop?
 
* Screen brightness. How do I manage screen brightness?
 
 
* Network and wireless. How do I get my wireless working?
 
* Media buttons. How do I configure the function of those buttons on my laptop?
 
* Touchpad. How do I configure the sensativity, acceleration, button function and scroll borders for my Synaptics or Alps touchpad?
 
 
All of these points are important to take into consideration when getting a laptop set up the way you like. Fortunately, Arch Linux provides all the tools and programs necessary to take complete control of your laptop. These programs and utilities are highlighted below, with appropriate tips tutorials.
 
 
 
Note: the following links may be useful:
 
 
* [http://www.linux-on-laptops.com/ http://www.linux-on-laptops.com/]
 
* [http://www.linlap.com/ http://www.linlap.com/]
 
 
= Power Management =
 
Power management is very important for anyone who wishes to make good use of their battery capacity. The following tools and programs help to increase battery life and keep your laptop cool and quiet.
 
 
== Battery State Monitoring Utilities ==
 
 
Battery state can of course be read with acpi from the terminal. Acpi can be installed with
 
 
$ pacman -S acpi
 
 
A simple battery monitor that sits in the system tray is [http://aur.archlinux.org/packages.php?ID=24694 batterymon] which can be found in the [[AUR]].
 
 
== Cpufrequtils ==
 
 
[[Cpufrequtils]] provides CPU Frequency Scaling, a technology used primarily by notebooks which enables the OS to scale the CPU speed up or down, depending on the current system load and/or power scheme. For quick and easy installation and setup, please view the [[CPU Frequency Scaling]] article.
 
 
== Pm-utils ==
 
[[Pm-utils]] provides a suspend and powerstate setting framework. Pm-utils should be used with cpufrequtils to provide a complete power management solution.
 
 
== Lapsus ==
 
[[Asus_G1#The_Lapsus_daemon_.26_KDE_applet|Lapsus]] is a set of programs providing easy access to many features of various laptops. It currently supports most features provided by asus-laptop kernel module from ACPI4Asus project, such as additional LEDs, hotkeys, backlight control etc. It also has support for some IBM laptops features provided by IBM ThinkPad ACPI Extras Driver and NVRAM device.
 
 
== Install PowerTOP ==
 
[http://www.lesswatts.org/projects/powertop/ PowerTOP] is a handy utility from Intel that displays which hardware/processes are using the most power on your system, and provides instructions on how to stop or remove power-wasting services. Works great for mobile Intel CPUs; provides the current CPU state and suggestions for power saving. Also works on AMD systems, but does not provide as much information about the CPU state. Install with:
 
 
# pacman -S powertop
 
 
== Laptop mode tools ==
 
Install [[Laptop Mode Tools]] with:
 
 
# pacman -S laptop-mode-tools
 
 
* The configuration files can be found in /etc/laptop-mode/laptop-mode.conf and /etc/laptop-mode/conf.d/*
 
* Be sure to add ''laptop-mode'' to the DAEMONS array in /etc/rc.conf
 
* Be sure to go through the config files, as many powersaving features are not enabled by default.
 
 
See [http://bbs.archlinux.org/viewtopic.php?id=39258 this thread] for more information.
 
 
== Powernowd ==
 
[[Powernowd]] is a program for powering down CPUs dynamicly, which can be run either on an AMD-based system or an Intel-based system.
 
 
Install it with:
 
# yaourt -S powernowd
 
 
To configure it, just edit your /etc/conf.d/powernowd:
 
OPTIONS="-q -u 15 -l 5"
 
 
== Suggestions for saving power ==
 
''Note:'' Not only are these not needed if using laptop-mode-tools, but using laptopmode also gives you the benefit of applying them only when desired (ie, while the AC cable is unplugged).
 
=== Disk-related tweaks ===
 
Disable file access time: every time you access (read) a file the filesystem writes an access time to the file metadata. You can disable this on individual files by using the chattr command, or you can enable it on an entire disk by setting the ''noatime'' option in your fstab, as follows:
 
 
/dev/sda1          /          ext3          defaults,noatime          1  2
 
 
[http://www.faqs.org/docs/securing/chap6sec73.html Source]
 
 
:''Note'': disabling atime causes troubles with [[Mutt|mutt]] and other applications that make use of file timestamps. Consider compromising between performance and compatibility by using mount option relatime instead, or look into [http://wiki.mutt.org/?MaildirFormat mutt work-around for noatime].
 
 
To allow the CD/DVD rom to spin down after a while, run the following:
 
 
/usr/bin/hal-disable-polling --device /dev/scd0
 
 
=== Other tweaks ===
 
These are some generic suggestions that will work with most laptops.
 
 
Add the following to ''/etc/modprobe.d/modprobe.conf'':
 
 
options usbcore autosuspend=1
 
 
 
Add the following to ''/etc/sysctl.conf''
 
 
vm.dirty_writeback_centisecs=1500
 
vm.laptop_mode=5
 
 
 
Add the following to ''/etc/rc.local'' (and make sure it gets executed at boot time)
 
 
/usr/sbin/iwpriv your_wireless_interface set_power 5
 
 
Source: [http://www.nervous.it/2007/11/linux-dell-xps-m1330/ here]
 
 
=== Hard drive spin down problem ===
 
Documented [https://bugs.launchpad.net/ubuntu/+source/acpi-support/+bug/59695 here]
 
 
To prevent your laptop hard drive from spinning down too often (result of too aggressive APM defaults) do the following:
 
 
Add the following to ''/etc/rc.local''
 
 
hdparm -B 254 /dev/sdX ''where X is your hard drive device''
 
 
You can also set it to 255 to completely disable spinning down.  You may wish to set a lower value if you move your laptop around as lower values park the heads more often and reduce the chance of damage to your hard disk while it is being moved.  If you don't move your laptop at all when you are using it, then 255 or 254 is probably best.  If you do, then you might want to try a lower value.  A value like 128 might be a good middle-ground.
 
 
Add the following to ''/etc/pm/sleep.d/50-hdparm_pm''
 
 
#!/bin/sh
 
 
 
if [ -n "$1" ] && ([ "$1" = "resume" ] || [ "$1" = "thaw" ]); then
 
hdparm -B 254 /dev/your-hard-drive > /dev/null
 
fi
 
 
and run "chmod +x /etc/pm/sleep.d/50-hdparm_pm" to make sure it resets after suspend.  Again, you can change the value 254 as you see fit.
 
 
Now the APM level should be set for your hard drive.
 
 
For some laptops, the option -S to hdparm can also be relevant (sets the spindown time for the drive). Note that all these options can also be configured using the [[Laptop_Mode_Tools | laptop-mode tools]].  This will allow you to set a high value when on AC and a lower value when you are running on battery power.
 
 
=== Tweaking the scheduler ===
 
For multicore and hyperthreading-enabled processors you may use sched_mc_power_savings and sched_smt_power_savings options respectively to make the scheduler keep idle as many cores as possible. To enable these options you can do
 
echo 1 > /sys/devices/system/cpu/sched_mc_power_savings
 
or
 
echo 1 > /sys/devices/system/cpu/sched_smt_power_savings
 
Echoing 0 will disable them. Also laptop-mode can be used to control shed_mc_power_savings (see the appropriate config file in /etc/laptop-mode/conf.d).
 
--[[User:Kasbah|Kasbah]] 16:14, 14 August 2009 (EDT)
 
 
= Touchpad =
 
To get your touchpad working properly, see the [[Touchpad Synaptics]] page. Note that your laptop may have an ALPS touchpad (such as the DELL Inspiron 6000), and not a Synaptics touchpad. In either case, see the link above.
 
 
 
= Special Buttons =
 
= Special Buttons =
To configure any special keys or buttons on your laptop, please refer to the following article: [http://www.linux.com/feature/118179 Customize your laptop keyboard with X and KDE]. Note that KDE is not required.
+
To configure any special keys or buttons on your laptop, please refer to [[Extra Keyboard Keys]]
 
 
= Hard disk shock protection =
 
There are several laptops from different vendors featuring shock protection capabilities. As manufacturers have refused to support open source development of the required software components so far, Linux support for shock protection varies considerably between different hardware implementations.
 
 
 
Currently, only one project, named HDAPS, support this kind of protection, which is prepared for IBM/Lenovo Thinkpads.
 
 
 
Just Check [[HDAPS|Hard Disk Active Protection System]].
 

Revision as of 22:51, 19 March 2010

Special Buttons

To configure any special keys or buttons on your laptop, please refer to Extra Keyboard Keys