Lenovo IdeaPad Y560
The Lenovo Ideapad Y560 is a multimedia laptop available with several different option packages. This wiki will focus on support for as many variations as possible. At the time of writing, the Ideapad Y560 is available with the following options:
CPU: Intel® Core™ i3-370M Processor ( 2.40GHz 1066MHz 3MB )
Intel® Core™ i5-460M Processor ( 2.53GHz 1066MHz 3MB )
Intel® Core™ i7-720QM Processor ( 1.60GHz 1333MHz 6MB )
Intel® Core™ i7-740QM Processor ( 1.73GHz 1333MHz 6MB )
Screen: 15.6” (1366×768) Widescreen
Memory: Up to 8GB ram
Graphics: ATI Mobility Radeon HD 5730
Lenovo's default partitioning scheme thankfully included an extended partition. Using a utility such as gparted, it is recommended to shrink your windows partitions to at least half the size of the drive and increase the extended partition to fill in the gap, then installing Arch within new logical partitions inside. Installing the bootloader to /dev/sda will allow it to boot into all of the operating systems, though you will need to chainload windows (chainloader +1 boot option, see the Beginner's Guide for an example).
The Lenovo Ideapad Y560's ATi 5730 graphics card works very well with both the open-source Radeon driver and the proprietary Catalyst driver, though there are minor performance differences to note:
Catalyst: Decent 2D performance, stock settings appear to work fine. 3D acceleration performance is highest with this driver, though 2D accelerated performance is not quite as good as the open-source driver. Noticeable performance reduction in fullscreen video performance (both applications such as VLC and web-based videos such as flash videos from sites like YouTube.
Radeon: Superb 2D and 2D accelerated performance, as well as decent 3D performance (though not as good as Catalyst). Fullscreen video is fine, and image-rendering programs/GPU-intensive applications tend to work well (with exception of 3D games, though this is under active development and so may have changed since the writing of this article).
Both drivers support overclocking, though the benefit of doing so on the Ideapad is negligible compared to the potential damage that can be done to the system, as the card will idle at about ~50-60C and can easily overheat due to the poor cooling system designed by Lenovo. [note: Admiralspark]
Taken from Catalyst
To install the proprietary ATi graphics drivers, use:
# pacman -S catalyst-dkms catalyst-utils
It remains to be seen what will be done when X.Org upgrades break the driver.
AUR is the alternative package to install, and it will pull in AUR as well, and will auto-recompile the kernel every time it is updated.
Autofglrx will run every boot, taking ~40 milliseconds to check if the module needs to be recompiled. This will preserve multiple fglrx modules for multiple kernels.
Once installed, you will need to configure the xorg.conf. Fortunately, a simple way to do this exists that will work with the 5730 without modification:
aticonfig --initial --input=/etc/X11/xorg.conf
Now reboot, and check operations with applications like glx-gears, glxinfo, etc. See the main Catalyst article for reference and more complete instructions.
Taken from ATI
The installation of the Radeon driver is quite simple:
pacman -S xf86-video-ati
uDev will automatically load the correct driver, and no further xorg configuration is necessary. However, there is a problem on our machines with the default behavior of Radeon. The ATi driver will default to full clock, or its highest speed setting. This will cause the machine to run very hot, causing it to overheat and lock up/BIOS forced shutdown at 100C under any decent CPU load, as they share a single copper heatsink that cannot cool both units fast enough. The solution is to use dynamic clock speeds (much like the kernel's ondemand governor), which will keep the GPU in a low-speed state until needed, also preserving battery life:
# echo dynpm > /sys/class/drm/card0/device/power_method
You can also use a profile power method:
# echo profile > /sys/class/drm/card0/device/power_method # echo auto > /sys/class/drm/card0/device/power_profile
This method appears to have better performance in some cases, though dynpm works well in all but the highest-usage cases.
For HDMI audio on the Radeon driver, see Radeon#HDMI_Audio
As of Kernel 3.2.x, wireless works out-of-the-box with the iwlwifi driver.
There is a bug in the kernel which causes the tg3 module to load before broadcom, rendering the Intel Ethernet adapter useless. To fix, you will need to change the following lines in your /etc/rc.conf:
Now the ethernet interface, eth0, should load without issue.
The Linux-Ideapad Kernel
TheAUR kernel is optimized for the Lenovo Y5xx laptops, though it should work on any laptop that uses the same chipset as the Ideapad. Includes all changes from the parent package by graysky AUR, as well as:
- Optimized for Intel Core2/i3/i5/i7 processors
- BFQ I/O enabled by default
- tun/tap driver for VPN use
- 1000MHz timer (reduced latency)
- Low-latency preemptible kernel options
- Networking filesystems: CIFS,
NFS client/serverAs of version 3.6.8-1, CFS is re-enabled
- Filesystem support added for NTFS, EXT4, EXT3, EXT2, VFAT, iso9660, as well as USB mass storage devices
- FUSE module for network filesystems
- iwlwifi driver
- Ideapad rfkill switch support
- Ideapad switchable graphics (non-i7 models that included the intel integrated graphics card with the ATi/nVidia)
- other small tweaks for performance, constantly being updated. Suggestions should be left on the AUR page.
- Many unused drivers switched on by default are disabled, reducing the final kernel size significantly
ALSA works fine with the sound card, using the snd_hda_intel module.
However, uDev does not automatically mute the speakers when a headset is plugged in, and will need to be scripted or done manually through alsamixer.
As of 11/29/2012, this issue has been corrected
You will want to edit the /etc/X11/xorg.conf.d/10-synaptics.conf file, as root, and replace the contents with the following options:
Section "InputClass" Identifier "touchpad" Driver "synaptics" MatchIsTouchpad "on" Option "TapButton1" "1" Option "TapButton2" "2" Option "TapButton3" "3" Option "VertEdgeScroll" "on" Option "VertTwoFingerScroll" "on" Option "HorizEdgeScroll" "on" Option "HorizTwoFingerScroll" "on" Option "CircularScrolling" "on" Option "CircScrollTrigger" "2" Option "EmulateTwoFingerMinZ" "40" Option "EmulateTwoFingerMinW" "8" Option "CoastingSpeed" "0" EndSection