Lenovo ThinkPad X230
After saving the above files, make sure to regenerate your init ram image by the command
mkinitcpio -p linux, and follow the steps in kernel parameters.
X230 has IPS or TN screen with 125.37 DPI. Refer to HiDPI page for more information.
The original configuration renders the touchpad quite useless, as it behaves very jumpily. Ubuntu Bugtracker offers a solution for this issue. Add the following
Section "InputClass" Identifier "touchpad" MatchProduct "SynPS/2 Synaptics TouchPad" # MatchTag "lenovo_x230_all" Driver "synaptics" # fix touchpad resolution Option "VertResolution" "100" Option "HorizResolution" "65" # disable synaptics driver pointer acceleration Option "MinSpeed" "1" Option "MaxSpeed" "1" # tweak the X-server pointer acceleration Option "AccelerationProfile" "2" Option "AdaptiveDeceleration" "16" Option "ConstantDeceleration" "16" Option "VelocityScale" "20" Option "AccelerationNumerator" "30" Option "AccelerationDenominator" "10" Option "AccelerationThreshold" "10" # Disable two fingers right mouse click Option "TapButton2" "0" Option "HorizHysteresis" "100" Option "VertHysteresis" "100" EndSection
Setting e.g. the motion-acceleration value in dconf to 2.8 works nicely.
Backlight control keys
Due to an issue with the firmware of several ThinkPads the backlight control keys (fn + F8/F9 on the X230) don't work correctly. Setting the brightness via e.g. the GNOME power control panel or altering the brightness value in sysfs is possible.
Suspend to ram
There is an issue with system shutdown with power saving tools that cannot distinguish sys devices. You will need to add to the systemd shutdown trigger on this machine or else you'll get a system reboot when you shutdown the machine. Put this in /etc/rc.local.shutdown and update and enable its service, if not already.
#!/bin/bash # /etc/rc.local.shutdown: Local shutdown script. # A script to act as a workaround for the bug in the runtime power management module, which causes thinkpad laptops to restart after shutting down. # Bus list for the runtime power management module. buslist="pci i2c" for bus in $buslist; do for i in /sys/bus/$bus/devices/*/power/control; do echo on > $i done done
[Unit] Description=/etc/rc.local.shutdown Compatibility ConditionFileIsExecutable=/etc/rc.local.shutdown DefaultDependencies=no After=rc-local.service basic.target Before=shutdown.target [Service] Type=oneshot ExecStart=/etc/rc.local.shutdown StandardInput=tty RemainAfterExit=yes
If the built-in microphone is not detected when using PulseAudio, the steps here may fix the issue: PulseAudio/Troubleshooting#Microphone not detected by PulseAudio.
Follow the main article: Power saving
Power saving kernel parameters in addition to graphics card power saving, are shown below.
acpi_backlight=vendor loads the vendor specific Backlight#ACPI driver (i.e. thinkpad_acpi) so the brightness keys (Fn + F8 and Fn + F9) work correctly.
Note that the
acpi_backlight=vendor kernel option also works with the standard Arch kernel (currently 3.7.10-1) and has the additional bonus that (Fn + spacebar) controls the keyboard lighting.
Users of TLP need to pay attention to a hardware bug according to which it is recommended to only use either the upper or lower charging threshold. The following configuration is recommended by the developer of TLP.
x230T (tablet version)
Multitouch screen for the x230t (tablet version)
Works out of the box with.
Wacom tablet input
Works out of the box with Wacom Tablet. See
- Microphone on-off key does not work out of the box