MAC address spoofing
There are two methods for spoofing a Media Access Control (MAC) address on Arch. Both of them are outlined below.
Method 1: macchanger
The first method uses macchanger, known in full as GNU MAC Changer, written by Alvaro Lopez Ortega. It provides a variety of features such as changing the address to match a certain vendor or completely randomizing it. The first step is to download it from [extra]:
$ pacman -S macchanger
After this, the MAC can be spoofed with a random address. The syntax is 'macchanger -r <device>'. Standard names for devices are eth0 (for Ethernet) and wlan0 (for wireless), if only one device of each type is connected. For a secondary device, it would be eth1 or wlan1.
Here is an example command for spoofing the MAC address of a device named eth0. NOTE: This must be done as root.
$ macchanger -r eth0
To randomize all of the MAC except for the vendor bytes (that is, so that if the MAC address was checked it would still register as being from the same vendor), you would run the command:
$ macchanger -e eth0
Finally, to change the MAC address to a specific value, you would run:
$ macchanger --mac=XX:XX:XX:XX:XX:XX
Where 'XX:XX:XX:XX:XX:XX' is the MAC you wish to change to.
NOTE: As well, a device cannot be in use (connected in any way or with its interface up) while the MAC address is being changed.
Method 2: Manual
This method also assumes that your device name is eth0. For clarification, read the second paragraph of Method 1.
First, you can check your current MAC address with the command:
$ ifconfig eth0
The section that interests us at the moment is the one that has "HWaddr" followed by a 6-byte number. It will probably look something like this:
The first step to spoofing the MAC address is to bring the network interface down. You must be logged in as root to do this. It can be accomplished with the command:
$ ifconfig eth0 down
Next, we actually spoof our MAC. Any hexadecimal value will do, but some networks may be configured to refuse to assign IP addresses to a client whose MAC does not match up with a vendor. Therefore, unless you control the network(s) you are connecting to, it is a good idea to test this out with a known good MAC rather than randomizing it at first.
To change the MAC, we need to run the command:
$ ifconfig eth0 hw ether XX:XX:XX:XX:XX:XX
Where any 6-byte value will suffice for 'XX:XX:XX:XX:XX:XX'.
The final step is to bring the network interface back up. This can be accomplished by running the command:
$ ifconfig eth0 up
If you want to verify that your MAC has been spoofed, simply run 'ifconfig eth0' again and check the value for HWaddr. If it worked, HWaddr should be whatever address you decided to change it to.