Difference between revisions of "Mumble"

From ArchWiki
Jump to: navigation, search
(Created page with "From [http://en.wikipedia.org/wiki/Mumble_%28software%29 Wikipedia, the free encyclopedia]: :''Mumble is a voice over IP (VOIP) application primarily designed for use by game...")
(Add Category)
Line 1: Line 1:
From [http://en.wikipedia.org/wiki/Mumble_%28software%29 Wikipedia, the free encyclopedia]:
From [http://en.wikipedia.org/wiki/Mumble_%28software%29 Wikipedia, the free encyclopedia]:

Revision as of 05:11, 2 February 2013

From Wikipedia, the free encyclopedia:

Mumble is a voice over IP (VOIP) application primarily designed for use by gamers, similar to programs such as TeamSpeak and Ventrilo.

This page goes over installation and configuration of both the client portion of the software (Mumble) and the server portion (Murmur).



Install mumble from the Official Repositories.


When you first launch the client, a configuration wizard will take you through the setup process. Settings can be changed later through the menu.

For a discussion of advanced settings, see the official documentation. The Mumbleguide is a good starting point.


The Mumble project maintains a good guide for setting up the server here: Murmurguide. What follows is a quick-and-dirty, abridged version of that guide.


Install murmur from the Official Repositories.

The postinstall script will tell you to reload dbus and set the supervisor password. The default configuration doesn't use dbus, so you can ignore that if you want. Setting the supervisor password is recommended, however.



If you use a Firewall, you'll need to open TCP and UDP ports 64738. Depending on your network, you may also need to set a static IP, port forwarding, etc.

Config File

The default murmer config file is at /etc/murmur.ini and is heavily commented. Reading through all the comments is highly recommended.


There is currently a bug that causes systemctl to hang when starting the murmur service after installing. A reboot will clear the issue, or you can create /run/murmur manually.

systemd-tmpfiles --create /usr/lib/tmpfiles.d/murmur.conf

Start and/or murmur with systemctl start murmur and systemctl enable murmur. If all went smoothly, you should have a functioning murmur server.