From ArchWiki
Jump to navigation Jump to search

Template:Article summary start Template:Article summary text Template:Article summary heading Template:Article summary link Template:Article summary link Template:Article summary text Template:Article summary heading Template:Article summary wiki Template:Article summary end

PowerTOP is a tool provided by Intel to enable various powersaving modes in userspace, kernel and hardware. It is possible to monitor processes and show which of them are utilizing the CPU and wake it from its Idle-States.


Install package powertop, available in Official Repositories.

Powertop was updated to 2.0 which comes with more features (Article from the H Open). For more information, see the Release Announcement.

Tips and tricks

PowerTOP suggests a few methods to reduce the power consumption further. However, in the console, PowerTOP does not display the parameters. To find out which ones are suggested, proceed as follows:

  • If you have changed parameters (e.g. in PowerTOP), reboot so that the system has default state of the parameters.
  • Use PowerTOP to produce a report on parameters: # powertop --html=powerreport.html
  • The last tab of the report now shows the actual parameters suggested by the tool to apply to save power.

You can apply these settings at boot by using module parameters, udev rules and sysctl. For details, see the power saving page.


Error: Cannot load from file

If you get an error like the following when starting powertop, you are likely to have powertop not allowed collecting enough measurement data yet. All you need to do is to keep powertop running for a certain time whilst being on battery.

Loaded 39 prior measurements
Cannot load from file /var/cache/powertop/saved_parameters.powertop
Cannot load from file /var/cache/powertop/saved_parameters.powertop

Calibration to prevent inaccurate measurement

If you experience inaccurate measurement, then it is likely that you need to calibrate powertop first. This can be done by running powertop with the --calibrate parameter.

# powertop --calibrate