Difference between revisions of "RT61 Wireless"

From ArchWiki
Jump to: navigation, search
(redirect: outdated, uses rt2x00 driver, missing AUR package)
(7 intermediate revisions by 4 users not shown)
Line 1: Line 1:
[[Category:Networking (English)]]
#REDIRECT [[Wireless Setup#rt2x00]]
The RT61 Driver is included in the official kernel-tree so you must only load the rt61 module using:
# modprobe rt61pci
If you want to load the module at startup you can add it to MODULES=() in rc.conf like this:
MODULES=(... fuse '''rt61pci''' snd-via82xx ...)
Some RT61 devices need to load the firmware (you can check it using the dmesg command) so you must install the rt2x00-rt61-fw package using:
# pacman -S rt2x00-rt61-fw
==Bringing up the interface==
===No encryption and WEP encryption===
Edit rc.conf to met your config:
wlan_wlan0='wlan0 essid <youressid>' #no encryption
wlan_wlan0='wlan0 essid <youressid> key open s:<yourWEPkey>' #WEP encryption
INTERFACES=(wlan0 lo) #among other interfaces
===WPA/PSK or WPA2/PSK===
The README file tells you how to configure the interface using iwconfig and iwlist commands. To set up the system to configure the interface at startup you can use the [http://aur.archlinux.org/packages.php?ID=16086 AUR package] scripts from klixon. Simply download 'rt61wpa' to '/etc/rc.d/rt61wpa' and 'rt61-wpa.conf.d' to '/etc/conf.d/rt61-wpa', configure the 'rt61-wpa' file and place 'rt61wpa' in your rc.conf DAEMONS array before 'network'. You also have to put
INTERFACES=(wlan0 lo) #among other interfaces
in your rc.conf.
==Master Mode==
This is currently not supported by legacy drivers [http://rt2x00.serialmonkey.com/phpBB/viewtopic.php?t=4203 Serialmonkey Forum]. Solution is to compile new kernel with some patches and using patched hostapd for beacons. [http://rt2x00.serialmonkey.com/phpBB/viewtopic.php?t=4582 Serialmonkey Again]

Revision as of 22:36, 3 August 2013