From ArchWiki
Revision as of 12:07, 23 August 2012 by Gen2ly (Talk | contribs) (Detect if device has SMART support)

Jump to: navigation, search

S.M.A.R.T. (Self-Monitoring, Analysis, and Reporting Technology) is a supplementary component build into many modern storage devices through which devices monitor, store, and analyze the health of their operation. Statistics are collected (temperature, number of reallocated sectors, seek errrors...) which software can use to measure the health of a device, predict possible device failure, and provide notifications on unsafe values.


The smartmontools package contains two utility programs (smartctl and smartd) to analyze and monitor storage devices. Install smartmontools from the official repositories.

Detect if device has SMART support

To check if the device has SMART capability (it may be necessary to add -d ata to specify it is an ATA derived device):

# smartctl -i /dev/<device>

(where <device> is sda, hda,...). This will give general information about the device, the last two lines will show if it is supported:

SMART support is: Available - device has SMART capability.
SMART support is: Enabled

If SMART is not enabled, it can be enabled by doing:

# smartctl -s on /dev/<device>

Test the device health

Three type of health tests that can be performed on the device (all are safe to user data):

  1. Short (the hightest-probability tests of detecting device problems)
  2. Extended (or Long; a short check with complete disk surface examination)
  3. Conveyance (identifies if damage incurred during trasportation of the device)

To view the device's available tests and the it takes to perform the tests do:

# smartctl -c /dev/<device>

To run the tests do:

# smartctl -t short      /dev/<device>
# smartctl -t long       /dev/<device>
# smartctl -t conveyance /dev/<device>


To get overall health status (gathered from various tests) do:

# smartctl -H /dev/<device>

To view the test result errors:

# smartctl -l error /dev/<device>

To view detailed test results:

# smartctl -a /dev/<device>

If no errors are reported the device is likely healthy. If there are a few errors this may or may not indicate a problem and should be investigated further. When a device starts to fail it is recommended to backup the device and replace it.

Monitor devices

Device(s) can be monitored in the background with use of the smartmontools daemon that will check device(s) periodically and optionally email any potential problems. To have devices monitored on boot, add smartd to the daemons array of rc.conf.

The smart daemon can be edited for more exact configuration in /etc/smartd.conf (the configuration is well commented) otherwise all tests are run on all devices. Or, each device can be specified and all tests run by doing (uuid's and device ID can be used for more exact matching):

/dev/<device> -a

Other options include:

  • -n standby,q to run diagnostics only when device is spun-up.
  • Details about smartd operations can be found in: /var/log/daemon.log.

Email potential problems

To have an email sent when a failure or new error occurs, use the -m option:

DEVICESCAN -m address@domain.com

To be able send the email externally (i.e. not to the root mail account) a MTA (Mail Transport Agent) or a MUA (Mail User Agent) will need to be installed and configured. Common MTAs are MSMTP and SSMTP) and MTUs are sendmail and Postfix.

Once the mail agent is setup the -M test option can be used to test if an email will be sent (restart the daemon immediately to discover):

DEVICESCAN -m address@domain.com -M test

GUI Applications

  • Gsmartcontrol — A GNOME frontend for the smartctl hard disk drive health inspection tool
http://gsmartcontrol.berlios.de/home/index.php/en/Home || gsmartcontrol