Difference between revisions of "Slime"

From ArchWiki
Jump to: navigation, search
m (slime-cvs is in the AUR)
(Remove out-of-date flag, replace link to .install file)
(One intermediate revision by one other user not shown)
Line 1: Line 1:
{{Out of date}}
 
 
[[Category:Development]]
 
[[Category:Development]]
 
== Introduction ==
 
== Introduction ==
Line 16: Line 15:
 
== Configuration ==
 
== Configuration ==
  
''From the [http://repos.archlinux.org/wsvn/community/slime-cvs/repos/community-any/slime.install .INSTALL] file.''
+
''From the [http://pkgbuild.com/git/aur-mirror.git/plain/slime-cvs/slime.install .INSTALL] file.''
  
 
To make use of slime, add the following lines to your [[Emacs#Customization|init file]]:
 
To make use of slime, add the following lines to your [[Emacs#Customization|init file]]:

Revision as of 19:00, 22 October 2013

Introduction

SLIME (Superior Lisp Interaction Mode for Emacs) provides a development environment for SBCL (detailed in this article), CMUCL, CLISP and other Lisp implementations.

The components required are:

  • emacs
  • sbcl
  • slime

Installation

Install emacs and sbcl from the official repositories and slime-cvsAUR from the AUR.

Configuration

From the .INSTALL file.

To make use of slime, add the following lines to your init file:

(setq inferior-lisp-program "/path/to/lisp-executable")
(add-to-list 'load-path "/usr/share/emacs/site-lisp/slime/")
(require 'slime)
(slime-setup)

Then run M-x slime from within emacs.

Alternatively, for a fancier slime setup, you can change the above lines to:

(setq inferior-lisp-program "/path/to/lisp-executable")
(add-to-list 'load-path "/usr/share/emacs/site-lisp/slime/")
(require 'slime)
(slime-setup '(slime-fancy))

Resources