Solid state drive/NVMe
NVM Express (NVMe) is a specification for accessing SSDs attached through the PCI Express bus. As a logical device interface, NVM Express has been designed from the ground up, capitalizing on the low latency and parallelism of PCI Express SSDs, and mirroring the parallelism of contemporary CPUs, platforms and applications.
The Linux NVMe driver is natively included in the kernel since version 3.3. NVMe devices should show up under
Extra userspace NVMe tools can be found inor AUR.
See Solid State Drives for supported filesystems, maximizing performance, minimizing disk reads/writes, etc.
NVMe SSDs are known to be affected by high operating temperatures and will throttle performance over certain thresholds.
Raw device performance tests can be run with:
# hdparm -Tt --direct /dev/nvme0n1
Power Saving APST
NVME Power Saving Patch
Andy Lutomirski has created a patchset which fixes powersaving for NVME devices in linux. The patch has been merged into mainline kernel v4.11.
To test if NVME Power Management is working, install
nvme get-feature -f 0x0c -H /dev/nvme[0-9]:
# nvme get-feature -f 0x0c -H /dev/nvme0
get-feature:0xc (Autonomous Power State Transition), Current value:0x000001 Autonomous Power State Transition Enable (APSTE): Enabled Auto PST Entries ................. ...
When APST is enabled the output should contain "Autonomous Power State Transition Enable (APSTE): Enabled" and there should be non-zero entries in the table below indicating the idle time before transitioning into each of the available states.
If APST is enabled but no non-zero states appear in the table, the latencies might be too high for any states to be enabled by default. The output of
# nvme id-ctrl /dev/nvme[0-9] should show the available non-operational power states of the NVME controller. If the total latency of any state (enlat + xlat) is greater than 25000 (25ms) you must pass a value at least that high as parameter
default_ps_max_latency_us for the
nvme_core kernel module. This should enable APST and make the table in
# nvme get-feature show the entries.
Samsung drive errors on Linux 4.10
On Linux 4.10, drive errors can occur and causing system instability. This seems to be the result of a power saving state that the drive cannot use. Adding the kernel parameter
nvme_core.default_ps_max_latency_us=5500 disables the lowest power saving state, preventing write errors.