Difference between revisions of "Talk:Broadcom wireless"

From ArchWiki
Jump to: navigation, search
(Problem with bcm43xx: new section)
(Problem with bcm43xx)
Line 23: Line 23:
  sudo touch /etc/modprobe.d/b43.conf
  sudo touch /etc/modprobe.d/b43.conf
  echo "options b43 pio=1 qos=0" | sudo tee -a /etc/modprobe.d/b43.conf
  echo "options b43 pio=1 qos=0" | sudo tee -a /etc/modprobe.d/b43.conf
[[User:Alvaro Martinez|Alvaro Martinez]] ([[User talk:Alvaro Martinez|talk]]) 05:24, 30 May 2013 (UTC)

Revision as of 05:24, 30 May 2013

b44 not load

I have the same configuration mentioned in the instructions. Dell Inspiron with BCM4401 and BCM4328 cards.

I still can not get these two cards to work together.

I have configured my machine just like the method stated but my ethernet card (b44) will not load.

Is there something else that could cause a conflict between multiple Broadcom modules?

Device not showing up

Hi, I'm new to editing wiki sites. So I don't really know if there's a convention about how people are going to interact when editing others pages. I added a sentence under the section "Device not showing up" that for me it worked only if i removed the exclamation mark before lib80211. I guess I should have posted something here first. I'm sorry if I have violated the process in anyway and you are free to remove it. But I leave it there so that you can decide if it fits in the page or not. Sorry for any trouble this might have caused.
-- Mabac (talk) 15 December 2010

broadcom-wl work well

I'm running a new dv7-7000 with a Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller (rev 01). I could not get this to work with the kernel drivers. The signal was so weak it wouldn't obtain an IP address from DHCP, even right next to the AP. Using broadcom-wl did the trick and things are working great.--Skarphace (talk) 05:16, 21 July 2012 (UTC)

Problem with bcm43xx

there is a common problem with some cards managed with the b43 driver, it gets disconnected randomly, with an error in dmesg saying:

kernel: No probe response from AP <addr> after 500ms, disconnecting.

but some googlin' gives the solution, i guess it should be included here as an advice: type the folowing in a shell:

sudo touch /etc/modprobe.d/b43.conf
echo "options b43 pio=1 qos=0" | sudo tee -a /etc/modprobe.d/b43.conf

Alvaro Martinez (talk) 05:24, 30 May 2013 (UTC)