Why does this article make it seem as if GPT disks are the only option? btrfs is fine on MBR disks. In fact the entire section on GPT partitioning is generic and entirely irrelevant to using btrfs for root. The section should merely point to gpt or mbr partitioning pages.
I have removed the relevant "disputed, unconfirmed blabla" bits about syslinux. Updated the part on installing the syslinux bootloader and added links to relevant parts of the syslinux wiki.The system install part still needs some changes to reflect the use of the AIS (arch-chroot, pacstrap etc). --Flako (talk) 08:46, 1 September 2012 (UTC)
Loop method not explained.
The page says...
"Warning: If you need swap support, either make a partition, or use the loop method detailed below. DO NOT simply use a swap file! Doing so will corrupt your btrfs filesystem."
However the loop method is not detailed below.
mkinitcpio-btrfs is not available
The following statement will always fail due to missing mkinitcpio-btrfs, this will of course be addressed later on the page, but it should be removed from this line as it will fail and confuse new users.
# pacman -r . -Sy base btrfs-progs mkinitcpio-btrfs <boot_loader> --ignore grub
The backup command is totally wrong and dangerous. Maybe its better to delete the parts concerning the backup and refer to other backup articles.
This page needs to be deleted. As of today (April 2013) no additional steps beyond those outlined in Installation Guide are required to install Archlinux on Btrfs (except filesystem creation, mkfs.btrfs). First, all entries regarding bootloader and partitioning are not specific to the Btrfs filesystem and shouldn't be here. Instead, future users should be redirected to their dedicated pages. Second, mkinitcpio-btrfs should have its own wiki page because it is not in the official repositories and it is not required to be part of the installation process. Cngn (talk) 11:25, 10 April 2013 (UTC)
As a new archlinux user, 'don't do this' is unhelpful without an alternative set of steps that is suggested instead. What steps need to occur in order to setup btrfs in the right form for snapshots etc?