Difference between revisions of "Talk:RAID"

From ArchWiki
Jump to: navigation, search
(Major re-write)
Line 17: Line 17:
 
== Major re-write ==
 
== Major re-write ==
 
I've done a pretty major overhaul to the article over the past week.  Please check it for accuracy.  One of my goals to was add a thread of continuity to the article so it reads as complete work rather than as a hodgepodge of advice.  I feel that mixing formatting types and utils for example is confusing to newbies.  I recommend sticking with GTP as you can see in the text.[[User:Graysky|Graysky]] ([[User talk:Graysky|talk]]) 23:22, 5 October 2013 (UTC)
 
I've done a pretty major overhaul to the article over the past week.  Please check it for accuracy.  One of my goals to was add a thread of continuity to the article so it reads as complete work rather than as a hodgepodge of advice.  I feel that mixing formatting types and utils for example is confusing to newbies.  I recommend sticking with GTP as you can see in the text.[[User:Graysky|Graysky]] ([[User talk:Graysky|talk]]) 23:22, 5 October 2013 (UTC)
 +
 +
== RAID 1 and Stride/Stripe ==
 +
 +
The section "Build the Array" mentions "In a RAID1 the chunk switch is actually not needed." and mdadm outputs "chunk size ignored for this level". cat /proc/mdstat outputs "65536KB chunk" regardless of what chunk size was chosen during creating.
 +
 +
Yet the section "Calculating the Stride and Stripe-width" has an example for RAID1 and uses a 64KB chunk size for calculating it. What is this math based on if it is impossible to choose a chunk size for RAID1

Revision as of 00:07, 13 January 2014

GPT partitions

zap (destroy) GPT and MBR data structures

 sgdisk --zap-all /dev/sdb

create largest possible new partition

 sgdisk --largest-new=1 /dev/sdb

check partition table integrity

 sgdisk --verify /dev/sdb

print partition table

 sgdisk --print /dev/sdb
Is this a mis-paste? I can't quite see why it is here?
jasonwryan (talk) 00:36, 19 July 2013 (UTC)
This is here because it's how I prepare hard-drives before setting them up for RAID. Not everyone uses GPT *yet* so didn't want to just stick it on the main page.. ~ AskApache (talk) 09:26, 3 October 2013 (UTC)

Major re-write

I've done a pretty major overhaul to the article over the past week. Please check it for accuracy. One of my goals to was add a thread of continuity to the article so it reads as complete work rather than as a hodgepodge of advice. I feel that mixing formatting types and utils for example is confusing to newbies. I recommend sticking with GTP as you can see in the text.Graysky (talk) 23:22, 5 October 2013 (UTC)

RAID 1 and Stride/Stripe

The section "Build the Array" mentions "In a RAID1 the chunk switch is actually not needed." and mdadm outputs "chunk size ignored for this level". cat /proc/mdstat outputs "65536KB chunk" regardless of what chunk size was chosen during creating.

Yet the section "Calculating the Stride and Stripe-width" has an example for RAID1 and uses a 64KB chunk size for calculating it. What is this math based on if it is impossible to choose a chunk size for RAID1