Trayfreq (pronounced trayfreek) is a GTK+ application released under GPL that lets you select your CPU's governor or frequency from a tray icon; therefore, trayfreq only depends GTK+ and something that shows tray icons.
CPU scaling requires you to have a kernel with the ability already built in or have an appropriate driver module loaded. If the former case represents you, then you do not have to worry. If the latter case represents you, follow the following steps:
Most modern computers use the module acpi-cpufreq. Other options include the p4-clockmod, powernow-k6, powernow-k7, powernow-k8, and speedstep-centrino drivers.
To load the driver:
# modprobe acpi-cpufreq
To load the driver automatically at startup add the module to /etc/rc.conf
# MODULES=( ... acpi-cpufreq ... )
CPU Governors Setup
Some CPU governors may not be built into your kernel, and you can add them to /etc/rc.conf to have them automatically load at startup. Again, edit /etc/rc.conf to load the governors' drivers.
# MODULES=( ... cpufreq-conservative cpufreq-powersave cpufreq-userspace cpufreq-ondemand cpufreq-performance ... )
Now, let's edit the configuration file for trayfreq.
# nano /usr/share/trayfreq/trayfreq.config
Everything will be commented out. Let's go through the options
- [events] -- the group events
- activate=/usr/bin/xterm -- this sets the program to launch when the tray icon is activated (left clicked usually)
- [governor] -- the group governor
- default=ondemand -- this sets the default governor to be set when trayfreq starts
- [frequency] -- the group frequency
- default=800000 -- this sets the default frequency to be set when trayfreq starts
Note that, if a default frequency is set, it will overide the governor.
If you want, you can have a configuration file in your home folder, but it cannot set the program to run when the tray icon is activated for security reasons. The file should be ~/.trayfreq.config.