Difference between revisions of "Xerox Phaser 3100MFP"

From ArchWiki
Jump to: navigation, search
 
Line 1: Line 1:
 
[[Category:Printers_(English)]]
 
[[Category:Printers_(English)]]
 
[[Category:HOWTOs_(English)]]
 
[[Category:HOWTOs_(English)]]
 +
=Introduction=
 +
This article describes setup of Xerox Phaser 3100MFP on Arch Linux x86_64. For this device Xerox provides only 32bit version of drivers and no open-source drivers are available, it makes setup a bit tricky. On x86 you should just install drivers from official site and configure as usual.
 +
=Installation=
 +
==Printer==
 +
OK, first of all we need to install CUPS:
 +
# pacman -S cups

Revision as of 06:46, 20 September 2010

Introduction

This article describes setup of Xerox Phaser 3100MFP on Arch Linux x86_64. For this device Xerox provides only 32bit version of drivers and no open-source drivers are available, it makes setup a bit tricky. On x86 you should just install drivers from official site and configure as usual.

Installation

Printer

OK, first of all we need to install CUPS:

# pacman -S cups