Xerox Phaser 3100MFP

From ArchWiki
Revision as of 06:50, 20 September 2010 by Lx (Talk | contribs)

Jump to: navigation, search

Introduction

This article describes setup of Xerox Phaser 3100MFP on Arch Linux x86_64. For this device Xerox provides only 32bit version of drivers and no open-source drivers are available, it makes setup a bit tricky. On x86 you should just install drivers from official site and configure as usual.

Installation

Printer

OK, first of all we need to install CUPS:

# pacman -S cups

Since 1.4.x version CUPS requires usblp kernel module to be unloaded, so next step is to remove module:

# rmmod usblp

If you don't want to do it any time you boot, just blacklist kernel module: {File|name=/etc/rc.conf|content=MODULES=(... !usblp ...)}} MODULES=(...!usblp...)

start cups [root@lxpc lx]# /etc/rc.d/cups start

Starting CUPS Daemon [DONE]