The TC 1100 is a slate tablet PC with a 10.2" screen and detachable keyboard.
Since the tablet has no internal cd-rom, booting from USB is the only option for getting into the installation media.
USB CD/DVD Rom
- Plugin a USB CD-Rom drive with installation disk
- Attach keyboard (USB or Dock are fine)
- Boot computer
- While in BIOS post screen, press the "jog-dial" located on the top left edge
- Select "CD-Rom" and press jog-dial again
For additional tablet related information, please read the Tablet PC page.
Nouveau works fine, including the 3D support
Install and setup the following
Suspending and Resuming
Resuming after suspending to disk causes the stylus to cease functioning. No data will be sent by the digitizer until it receives the
ISDV4_SAMPLING command, which is merely the ASCII character "1" (49). Unfortunately, the driver only sends that particular command during initialization. I suppose the proper way to fix this would be to modify the driver to recognize when it's resuming from a suspend to disk and send the command accordingly. As a workaround, run the
xset -display :0 q 2>&1 | head -1 | grep -Eqx 'No protocol specified|Keyboard Control:' && printf 1 >>/dev/ttyS0 (it requires ).
Install the Wacom page.package. A reboot may be required for Xorg to recognize the serial digitizer For additional help, see the
I have done a quick and dirty hack of to get the stylus-activated buttons working.
Unpack it, build it using makepkg, and install the resulting package with pacman. The stylus buttons will now generate keycodes when triggered, and these can be bound to actions by either your window manager or xbindkeys. The specific keycodes are as follows:
|Journal Launch||KEY_PROG3 (210)|
|Tablet PC Input Panel Launch||KEY_PROG4 (211)|
Right Hand Buttons
Side buttons work out of the box. Sometimes they do not respond until the unit is put into standby and then resumed